Image
image
image
image


PocketPORTTM Modem Configuration Guide for: Inseego (Novatel Wireless) USB800 (AT&T)

Model                       USB800 Inseego (Novatel)   USB800
ManufacturerInseego (Novatel)
Other NamesGlobal Modem USB800, USB800, U800, NC800, MiFi USB800
Antenna JackTS9
Pigtail Part #ANT-104-TS9
Auto Configured by PocketPORT 2? Yes. In firmware 2.2.123 and higher
Comments*** Support for this modem requires PocketPORT firmware version 2.2.123 or later.

Configure the USB800 to Auto Connect and enter the correct APN for your AT&T account via the USB800's internal web server (http://192.168.1.1) with the modem plugged into a PC before attempting to use the USB800 with the PocketPORT.

The USB800 must be in IPPT & End User Modes - with the modem in a PC, go to http://192.168.1.1/labtestinfo and select IPPT & End User Modes if the PocketPORT does not go online.

When operating in NAT Mode, PocketPORT LAN IP subnet must be changed from 192.168.1.x / 255.255.255.0 to avoid IP conflicts with this modem.

This modem takes longer than most others to connect to AT&T. Allow up to 2 minutes for the connection to complete.

The USB800 uses a nano sized (4FF) SIM card.

Back to Modem List Printer Friendly Version

image
image

image
image